Support Board
Date/Time: Sun, 06 Oct 2024 10:28:17 +0000
Post From: Multiple login and trade copier lag
[2023-06-03 16:15:52] |
gcUserStudies - Posts: 98 |
Regarding the lag, I have experienced similar issues. We know recently Rithmic had database issues (at least for Apex) that caused issues. However after that was resolved I have gone from no lag, to tons of lag. I'm using Denali feed also. The only thing I have found on my end is that it is related to GPU. Mine was maxed at 100% (I run OpenGL on my main instance of Sierra). If I disabled OpenGL, then Sierra itself would be pegged out with High CPU. Of course, check with Task Manager and add the GPU column if you have that setup. This was very frustrating issue that I could not figure out until yesterday and further more this morning. The only thing I had changed is updating the layout of my chartbook which seems innocent. However upon lots of testing/troubleshooting I found that depending on how my chartbook is setup I can take my GPU from 40% to 100%. As an example. If I run my main chartbook with all charts attached to the main window, GPU 100%. If I detach them all, then it drops in half when the windows are just scattered about. I also run a monitor extender to allow for two extra monitors. Again, I can have Sierra running fine GPU wise, but then move a single detached chart off to one of the extended monitors and have it go to 70%. Anyway, I'm not sure if any of this helps. But this is the only thing I have found on my end. Once I resolved my GPU issues by changing my layout, I have had zero lag now when using trade copier so far. Date Time Of Last Edit: 2023-06-03 16:16:21
|