Support Board
Date/Time: Tue, 16 Sep 2025 07:49:46 +0000
Post From: Lockup while in Configure Control Bar 1 >> Set Custom Tool
| [2022-01-04 22:22:21] |
| John - SC Support - Posts: 41827 |
|
Usually when you have this specific issue, in particular the "ding" when you try to select something else, it implies that the window is opening for the input you are trying to do, but it is opening off the screen so you can not see it, or access it. To fix this, select Window >> Reset Windows. Then try again and see if you get the proper window showing up. For information on the Reset Windows command, refer to the following: Window, CB and CW Menus: Reset Windows (Window) For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |