Support Board

Date/Time: Fri, 03 May 2024 08:53:25 +0000

Post From: Config Duplicate Control Bar Buttons

[2021-09-22 17:13:23] Link To Thread - Link To Post [Go To First Post]
John - SC Support - Posts: 31334
It is very hard for us to follow the information you have provided, although we do appreciate the effort. In general, it can be hard to follow what needs to happen, but the general idea is simply that you are tying a Control Bar button to a tool AND configuration for that tool. So you need to ensure that you have your configurations set properly and that the Control Bar buttons are referencing the right configurations. Therefore, in your case, you need to have Tool Configuration 1 for the Arrow tool to have a Green color and Tool Configuration 2 for the Arrow tool to have a Red Color. Then when setting up the Control Bar Buttons, you set the following: - Tool Button 1: Arrow; TC1 - Tool Button 2: Arrow; TC2 It sounds like you have the general setup correct, but something is missing from what we have gone over above. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing