Support Board

Date/Time: Thu, 02 May 2024 08:15:06 +0000

Post From: Daily Net Loss Management apparent issue?

[2021-05-06 20:22:23] Link To Thread - Link To Post [Go To First Post]
User98657 - Posts: 304
Thanks John, I did not know that. But I've just checked that setting on the chart off which I was trading today and it is set at 0.5, which would be accurate for Micros (M2K). Interestingly, the other chart I monitor, and was previously trading off of is set at 5.00, which of course would be accurate for the RTY. Let me explain further: To make my new trigger chart I duplicated my existing 6tick Renko, M2K chart. I changed this new chart to show me the RTY and set up the M2K in the Trade and Current Quote Symbol. I did this at the same time and perhaps that's why it remained set at 0.50 per tick, I'm not sure. In any event, the chart I was trading off of today is set to a Micro setting, albeit accidentally. The chart I duplicated on the other hand was changed from M2k to RTY, and saved. I then went back in and put in and inserted the M2K into the Trade and Current Quote Symbol window, and selected the Use As Trade Only Symbol checkbox. I'm guessing when I changed it to RTY it changed the tick value from the previous 0.5 to the current 5.0. You may not need any of that. But is it possible that it is pulling that higher level off of the other chart? That wouldn't seem to make sense, but I guess I could have inadvertently caused a conflict. Date Time Of Last Edit: 2021-05-06 20:23:02