Support Board
Date/Time: Thu, 03 Jul 2025 15:34:59 +0000
Post From: Cutting Parallel Rays - Odd behavior
| [2020-08-29 18:02:59] |
| User290496 - Posts: 64 |
|
Just noticed the following, and cant's seem to find any documentation on this odd behavior: When I draw a parallel ray and then cut it- the multiple lines of the parallel ray (in my case 3 lines, as I have one set between the two parallel rays at 50%) get cut at an odd angle instead of straight, or even at an angle that matches the starting angle of the rays. The parallel rays, after getting cut, then also somehow extend themselves BACKWARDS in time by a few bars. I have 'Allow Horizontal Shift' enabled, which I understand is for allowing you to draw your second parallel line further forward or backwards, but do not understand why the behavior would cause these two issues to arise after a cut. Note- the issue does not present if this option is not enabled. This causes me two issues: I cannot get the lines cut where I want them to get cut (where I place my cursor and left click to cut), and also the lines randomly extending themselves backwards in time after getting cut interferes with the rest of my chart. Cheers Date Time Of Last Edit: 2020-08-29 18:12:00
|