Support Board

Date/Time: Fri, 19 Apr 2024 20:41:36 +0000

Post From: Sent log from Sierra chart installer

[2019-07-26 04:54:16] Link To Thread - Link To Post [Go To First Post]
Sierra Chart Engineering - Posts: 104368
We assume you are referring to the Width settings for the first 4 subgraphs. As such, if you are using the P&F OHLC bars, rather than the P&F X-O columns, then the controls for the graphics settings for the OHLC bars is through the Global Settings. In this case, you will want to go to Chart >> Graphics Settings - Chart for this particular chart and then uncheck the option for Use Global Graphics Settings instead of These Settings. Then set the particular graphics settings as you want for this chart. The four options you want are the following: - Bar High-Low Down - Bar High-Low Up - Bar Open - Bar Close Refer to the following for more information on adjusting Graphics Settings: Graphics Settings Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, change to the Teton service: Sierra Chart Teton Futures Order Routing