Support Board

Date/Time: Wed, 08 May 2024 02:42:51 +0000

Post From: ACSIL: Automate Release/Allow DLL Load when building?

[2019-05-17 00:33:05] Link To Thread - Link To Post [Go To First Post]
User980156 - Posts: 1
Dear Support, I am a new user also looking at how one speeds up the process of trying studies, like the original poster. The UDP commands to release and reload the DLLs are useful, but these do not cause the custom study, as it appears on the current chart, to update to the newly loaded study. e.g. Assume a custom study was already on my chart. I make some changes, rebuild and the DLL is reloaded. However, the study will not update on the chart until I 'Remove' (manually) the existing study from the Studies pane, and then re-add via 'Add Custom Study'. Using 'Reload' or 'Reload and Recalculate' from the 'Chart' menu appears to force no changes, and the former is the only way to update the study on the chart. Are you able to add UDP commands so that this can also be accomplished? This would make the process as smooth as possible. Thank you. Edit* the function I am requesting is identical to what the OP described in his words as 'hot-replace'. Date Time Of Last Edit: 2019-05-17 00:40:36