Support Board

Date/Time: Fri, 03 May 2024 16:06:09 +0000

Post From: Universal Renko bar fill on new bar creation

[2017-11-21 19:53:26] Link To Thread - Link To Post [Go To First Post]
User531934 - Posts: 11
I checked the new pre-release, AT1647, yesterday and today, though today is a bad day to compare due to lack of choppiness (in the chop and at reversals are where the differences are most obvious). I tried the 4-2-5, 4-2-6, and 4-2-7 settings for the Flex Renko Inverse bars and I tried all New Trend Bar... settings for each. I was unable to find a good match to the desired renko bars. Yesterday, I also reverted back to the AT1614 release and compared the 4-2-6 universal renko bars to the desired bars. The match was quite good except for 2 bars at the end of a bull run (see attached). The AT1614 4-2-6 renko is the closest match I've found so far, but it's not perfect as shown in the attachment.


171120 uni-Renko comparison.doc - Attached On 2017-11-21 19:39:18 UTC - Size: 183.5 KB - 370 views