Support Board

Date/Time: Fri, 03 May 2024 19:58:54 +0000

Post From: Universal Renko bar fill on new bar creation

[2017-11-03 02:55:46] Link To Thread - Link To Post [Go To First Post]
Sierra Chart Engineering - Posts: 104368
We are still looking over your document but there is no need for all these details, at least we do not think so. There was a problem where the reversals were just not handled right on Flex Renko and Universal Renko in the last couple of versions. The offset just was not being applied. This will be fixed with a new version out tomorrow. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, change to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2017-11-03 03:19:07