Support Board
Date/Time: Wed, 30 Apr 2025 10:48:42 +0000
Behavior of the Add Trade Volume to pulling/stacking setting
View Count: 52
| [2025-04-25 17:39:31] |
| User293778 - Posts: 22 |
|
Hi, The documentation about the "Add Trade Volume to pulling/stacking" I think is a little scarce and watching the DOM I am not able to figure out how that setting really works. Could you please confirm that the following examples would be correct? 100 lots sit at a level and a 40 lot trade takes place. Nothing else happens. End Result: 60 lots still remain at that level. Then: - Setting OFF: Pulling/Stacking shows 0 (traded lots are discarded) - Setting ON: Pulling/Stacking shows -40 (-40 traded) 100 lots sit at a level and a 40 lot trade takes place and 25 additional contracts are PULLED. End Result: 35 lots still remain at that level. Then: - Setting OFF: Pulling/Stacking shows -25 (traded lots are discarded) - Setting ON: Pulling/Stacking shows -65 (-40 traded plus -25 pulled) 100 lots sit at a level and a 40 lot trade takes place and 50 additional contracts are ADDED. End Result: 110 lots still remain at that level. Then: - Setting OFF: Pulling/Stacking shows 50 (traded lots are discarded) - Setting ON: Pulling/Stacking shows 10 (-40 traded plus +50 added) Thank you!! |
| [2025-04-25 18:10:37] |
| John - SC Support - Posts: 39559 |
|
Your understanding is correct.
For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: