Support Board
Date/Time: Wed, 30 Apr 2025 10:53:48 +0000
Peaks Valley problem
View Count: 117
| [2025-04-11 21:37:52] |
| XL - Posts: 17 |
|
The VbP sensitivity lines for TPO chart Peaks and Valleys remain unchanged, even after adjusting the sensitivity. I'm using Version 2751 (64-bit). I am encountering this issue with two TPO charts. To avoid cluttering the charts, I currently have the setting set to "None." This setting has been intermittently problematic, so I tend to avoid making extensive changes to prevent disrupting the charts further. However, at this point, I am unable to get this setting to function correctly and need assistance. Before resorting to recreating the charts from scratch—which is quite time-consuming—are there any known issues with this setting or alternative solutions I could try? |
 peakvalley99.png / V - Attached On 2025-04-11 21:28:22 UTC - Size: 114.92 KB - 33 views peakvalley10.png / V - Attached On 2025-04-11 21:28:28 UTC - Size: 114.63 KB - 24 views |
| [2025-04-15 17:15:17] |
| John - SC Support - Posts: 39559 |
|
Which lines on the chart are the Peaks? Also, at some point, if you are not getting any lines, increasing the sensitivity will not make any difference. So if you are not getting any lines with a value of 10, then you will not get any lines with a value of 99 - you would need to decrease the sensitivity to get more lines to show. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: